Pennsylvania’s largest coal power plant set to retire

1888 MW Homer City facility will close by July

The largest coal-fired power plant in Pennsylvania will shutter by July, according the U.S. Energy Information Administration (EIA).

The 1888 MW Homer City Generating Station in Pennsylvania began generating electricity in 1969, when Units 1 and 2 entered service. Unit 3 was added in 1977.

According to the EIA, oal plants across the country are retiring; U.S. coal-fired capacity has contracted from 313 GW in 2005 to around 196 GW today. The Homer City coal-fired power plant was built before the turn of the century and was designed to provide base load power, operating nearly continuously to meet the minimum amount of regional power demand. Recently, coal plants have struggled to effectively compete in competitive U.S. power markets against newer, more efficient, natural gas-fired, combined-cycle power plants, the EIA said.

The Homer City plant was built near coal reserves and included what was then a high-capacity (345 kilovolt) transmission line to service areas in western New York and eastern Pennsylvania. For 30 years, the plant operated almost continuously, achieving a utilization rate of near 90%.

In 1999, the Homer City plant sold for $1.8 billion, corresponding to a period when Pennsylvania was deregulating its electricity market. At that time, coal-fired generation accounted for about 53% of the nation’s power supply; natural gas only accounted for about 12%. Since then, those roles have nearly reversed; natural gas is now the source of 40% of the electricity in the United States, and coal has dropped to 20%.

The market landscape changed for the Homer City plant at the turn of the century. New emissions standards for power plants under the Clean Air Act required the plant to install FGD scrubbers on Unit 3 in 2001 and on Units 1 and 2 in 2014. Pollution control upgrades in 2014 cost the plant owners a reported $750 million. Ownership of the plant changed after bankruptcy in 2017.

Driven by the ramp up of drilling and fracking to produce natural gas from the Marcellus and Utica shale formations in the region, many new natural gas-fired power plants were built in Pennsylvania. As new natural gas-fired plants were built, the Homer City plant was dispatched more intermittently for load following instead of for base load. This change increased annual maintenance costs for the Homer City plant, on top of the debt incurred from the pollution control upgrades.

Load-following plants adjust their power output as demand for electricity fluctuates throughout the day and by season. In contrast, base load power plants are usually run at near maximum output and are only taken offline to perform annual maintenance or repairs. As the Homer City plant became less competitive economically and was dispatched for load following rather than for base load power, the plant generated less electricity, and its capacity factor dropped. The Homer City plant was operated at an annual capacity factor of 82% in 2005. The capacity factor dropped to 20% in 2022, contributing in the decision to retire the plant.

STAY CONNECTED



Receive the information you need when you need it through our world-leading magazines, newsletters and daily briefings.

Sign up

POWER SOURCING GUIDE

The trusted reference and buyer’s guide for 83 years

The original “desktop search engine,” guiding nearly 10,000 users in more than 90 countries it is the primary reference for specifications and details on all the components that go into engine systems.

Visit Now

CONNECT WITH THE TEAM
Becky Schultz Vice President of Content Tel: +1 480 408 9774 E-mail: [email protected]
Julian Buckley Editor Tel: +44 (0) 1892 784088 E-mail: [email protected]
Chad Elmore Managing Editor Tel: +1 262 754 4114 E-mail: [email protected]
Josh Kunz Power Progress Brand Manager Tel: +1 414 379 2672 E-mail: [email protected]
Roberta Prandi Power Progress International Brand Manager Tel: +39 334 6538183 E-mail: [email protected]
CONNECT WITH SOCIAL MEDIA